Once you do get it removed, put some good marine grease back on the splein
before putting prop back on. I have been doing that for years with my boats
since experiencing the same problem your talking about. Works for me just
fine.






"noah" wrote in message
...
On Sat, 1 Nov 2003 07:08:27 -0600, "Fred" wrote:

I have a mercruiser alpha 1. I would like to remove the prop and
lubricate
the shaft, but it won't budge. Any suggestions?


I have the same outdrive.
If it was me, I would try a product called "PB Blaster". Similar to
WD-40, but better IMO.

Soak the shaft, as much as possible, with the "PB Blaster", and tap on
the prop housing with a rubber mallet. Repeat. Repeat again.

If you use a puller, be careful and go slow. It doesn't take much
force to "yoink" an aluminum prop.

Good luck,
To email me, remove the "OT-" from wrecked.ot-boats.noah.
...as you were. )