On Mon, 16 Aug 2004 19:50:12 +0200, "Steve Lusardi"
wrote:

Lisa,
NMEA interfaces are slow and bit serial (EIA RS-232). The protocol is very
basic and there is no provision for either addressing or data collisions. As
you stated, your solution is incorrect, the device to use is called a
statmux or statistical multiplexor in general. Specifically, there are
multiplexors available for this purpose that prevent data collisions and
allow orderly sentence broadcast. Contact a qualified nav equipment dealer
for further info. These devices are inexpensive and available.
Steve

Since Lisa was only proposing a single "talker" a mux is superfluous.
No collisions could occur. The only issue is whether the two loads
would reduce the signal too much.

But, since you mention it, where are there inexpensive muxes? I had
one once until it was hit by lightning, but it was very expensive at
the time.

Thanks




Rodney Myrvaagnes NYC J36 Gjo/a


"Wanting to meet a writer because you like his work is like wanting to meet a duck because you like pate."
Margaret Atwood