(Jacques) wrote in message . com...
Daniel wrote in message
Ralph

Not so uncommon and may be due to a malfunctioning of the exhaust/raw
water discharge circuit.
Sometimes it is just a vent that is plugged and permits a backflow of
water into the cylinders after shutting off the engine. The water, then,
seeps between the pistons and the cylinder walls into the sump.
Sometimes this problem, if not understood early, may cause the blow up
of the engine head at the next attempt to start the engine.

I second that. Also look in an exhaust system design flaw. Could the
seawater siphon back?

Jacques
http://bateau.com

Water is commonly found in engine crankcases where the engine is
run for short periods. Water vapour is a byproduct of combustion, and
as there's always a bit of combustion gas escaping past the rings into
the case, it will condense there and mix with the oil. The engine
needs to be run long enough to get the oil up to 180 degrees for a
half-hour or better to eliminate water that accumulated during a cold
run.
What's your block temp like? Too cool? Do you have an oil temp
gauge? Are you running the engine for a few minutes in the off-season
to "circulate the oil?" Bad deal.
Oil breaks down in the presence of water and metals, and forms
acids from the sulfur and chlorine compounds in the oil. Corrosion of
bearings and other stuff happens. It's what wrecks the engines in
older cars and aircraft that have low hours or miles on them: they
look good to a buyer, but the damage is inside, unseen. Trying to
convince people that short runs are bad is often impossible.

Dan