I've siphoned my 36 gal inboard tank with a small line out the bilge drain
plug. My tank is located aft pretty close to the back of the boat and it
was fairly easy to do.

"Camilo" wrote in message
...
The discussion about removing motor oil made think of this.

What's the best way to pump a large quantity of fuel (gas / oil mix) out
of
a built in tank. The tanks are about 25 gallons each and I want to pump
them
completely dry into 5 gallon cans.

I have a siphon and know how to use it, but it is difficult to impossible
for this.

In the past, I've used a cheap, little plunger-type hand pump with a tube
going down into the tank and another tube going to the 5 gallon tank.
This
worked OK - but not really well. The pump was pretty small and therefore
took way too many pumps per gallon, and the handle was just a little knob
and therefore difficult and tiring to use.

So, I'm looking for a better solution for moving 25 gallons of gas from a
built in tank to 5 gallon cans if anyone has any ideas. An electric
solution or a larger capacity hand pump with a good size handle would be
OK.

If I were to rig up an electric fuel pump, exactly how would I do that?
And, what is a typical pumping rate for this?

Many thanks in advance.
Cam