frank1492 wrote:

For starters, will the wise guys (and their wives) who thought I
was so stupid please google "paddle wheel transducer" and see what
comes up? Thanks.

I get a lot of hits on transducers that measure flow or movement,
nothing about depth. And it was a statement made in ignorance that was
funny when read. It is that simple.

If the transducer is mounted inside the boat, I would assume
it would be found just above the port above the paddle wheel,
correct?

Not necessarily. It could be a in hull, thru hull, or transom mounted
model. Look at them he

http://www.airmartechnology.com/airm...wn.asp?Type=FF

I'd expect to find anything from a nearly flat surface (about the same
amount of protrusion as a through hull inlet or discharge fitting) but
with no hole in it. Or maybe a smoothly faired lump of bronze with an
inch or two of protrusion.

And could that port be clogged with barnacles even though
the paddle wheel itself appeared clean?

A transducer is not a port, it has no opening or hole. It is like a
small combination magnetic speaker and and microphone. It generates
sound waves (inaudible to the human ear) that travel through the water.
Then it shuts up, listens for a return, and sends that back to the
display module where the return is processed.

It will generally look like a flat surface and will be aimed more or
less straight down. Forget the paddle wheel. It has nothing to do with
depth finding. Forget anything that might have a hole in it. Look for
something that looks something like the ones in the photos at the Airmar
link.

I will try to find that transducer and hope it is not mounted
under the gas tank!

Unlikely location. But the short slightedness of boat builders can't be
underestimated. Worst case, if you have a display, follow the coaxial
cable that comes out of the back of the display and you'll find a
transducer. Or you may find a pair of wires that go to a a processor
(the brains of the operation) that may be mounted below decks in the
same general area as the transducer.

Thanks to those who have tried to help.

You're welcome.

Jack

--
Jack Erbes in Ellsworth, Maine, USA - jackerbes at adelphia dot net
(also receiving email at jacker at midmaine.com)