"Tim" wrote in message
...
On Apr 21, 12:09 pm, "Jim" wrote:
"Tim" wrote in message
...
On Apr 21, 9:56 am, "Jim" wrote:
"Jim Rojas" wrote in message
news:WX0Pj.1566$Ks1.1408@trnddc01...
It's a standard utility pump I pick up at Harbor Freight. It was only
$40.
I can always replace it with a continous duty model at a later time.
It
is
cheap enough to carry a spare, or replace it every year. Heck, an
impeller
kit is $40 anyway. This setup would only take several minutes to
change
out if the pump fails.
Jim Rojas
Jim wrote:
Sorry. Carry on. When you said electric pump, I was thinking fuel
pump.
The only caution I can think of is that the pump you are using might
jam
or clog If it wasn't designed to pump dirty water.
"Jim Rojas" wrote in message
news:nISOj.1538$Ks1.1380@trnddc01...
I didn't replace the fuel pump, and don't have any plans to.
The choke circuit only activates the 30A relay. The pump itself is
on
a
separate 20 amp fuse on the battery selector switch.
I installed a temporary garden hose 2 way splitter on both ends of
the
water pump. On the in side, one hose goes to the raw water inlet,
the
other goes to a short hose to allow quick connection for flushing in
my
driveway. On out side, one hose goes to the heat exchanger, and the
other goes to a 1/4 hose reducer that acts like a weep hole on an
outboard or jetski. This allows a visual indication at all times
that
the electric pump is working.
Jim Rojas
Jim Rojas
Jim wrote:
"Jim Rojas" wrote in message
news
BJOj.1591$pn4.872@trnddc03...
Yeah...that I am an idiot... 
The electric pump works great! I had to install a relay to
activate
the pump. The relay is hooked up in parallel to the electric choke
circuit, so it will turn on/off when you turn the key.
Not such a good idea. You need to buy a oil pressure switch and
power
the fuel pump from it. You also need to pull power from the starter
solenoid S terminal to run the pump while cranking the engine. I
hope
your electric fuel pump is of the Coast Guard approved variety.
And it's certified ignition protected by the Coast Guard for use in
enclosed
engine compartments , right?- Hide quoted text -
- Show quoted text -
I can't say, but I doubt if it is. But then again. a lot of stuff on
boats isn't CC "aproved" from the factory.
I would have perhaps done things differently, but if he's satisfied
with how it works then I suppose that's fine. After all, we're talking
a runabout boat here.
I have to disagree with you here Tim. Runabouts can explode too. It could
happen in a crowded marina or a gas dock, or a raft up party etc. Innocent
people could be killed or injured because of an improperly maintained
runabout.- Hide quoted text -
- Show quoted text -
Oh, no doubt, Jim. and I'm not really discounting the idea that it's a
good thing. But it's amazing how many boats you'll find that have
google, jerry rigged things onboard.Again. I'm not saying it's a good
thing....
But if a person uses some common sense and has a decent knowledge
about spark/flame arresting, and can adapt to such, then there
shouldn't be a problem.
We can only hope ;-