You would probably have to install the ATU at the top of the mast as well,
and the voltage maximum would likely be at the deck level, and this might be
interesting for those leaning against the backstay?

Regards

Bob
GM4CAQ

Simply Blue Too
Clyde


"Geoff Schultz" wrote in message
.. .
I'm posting this for a friend from the forum on www.FreedomYachts.org. I
know that there are a lot of good radio people here and not many on that
forum.

-----------

I have one of these catketches, no shrouds and an overhanging mizzen boom.
In the next two years, I need to install an SSB transceiver antenna. I
have
two stainless adjustable backstays with block and tackle at the bottom.
Normally, in their idle mode, they are athwart ships of the mizzen. When
in
use, The luff backstay tackle is set on the luff transom corner and
tensioned. I know some people use this backstay as an antenna.

What I want to know is if someone has experience with positioning the
balun
at the TOP of the backstay and feeding the coax cable from the top of the
mast down to below decks. Normally, the balun is at the bottom end of the
antenna and the coax is fed in from there. This is not possible (or at
least practical) with a backstay that is moved around at the bottom end.
As
far as my limited knowledge goes, the coax has to be included in
calculating the required antenna length.

----------

-- Geoff
www.GeoffSchultz.org