On Oct 23, 4:46�pm, Scott Dickson wrote:
On Oct 23, 3:11�pm, Tom Francis - SWSports





wrote:
On Fri, 23 Oct 2009 12:03:26 -0700 (PDT), Scott Dickson

wrote:
My Chris Craft has one forward Bilge Plug on one side of the hull
beside the keel. When I store the boat, I drop the nose to allow water
to escape. The trouble is that it only drains on that side. Water
still stays in the boat on one side. Would anyone install another
matching plug on the other side by themselves, or would you have a Pro
do it?
Just curious. I have to end this problem, and wondered how tough this
operation is. There's lots of room to work in the area.

Is this the Corsair? �Interesting configuration. �The boat I had,
which was a year older than yours (I think), had a transom drain plug
also. �Your's doesn't?

In any case, it's not hard to do - I've seen it done. �It's a guestion
on a hole saw, brass insert, brass screws and some sealant - your
choice, but I'd use 3M 5200. �The hull in that particular location on
that boat is fairly accessible.

Then again, you might want a pro to take the liability for doing it.

Up to you really.

Yes , it is the Thompson Lakes Corsair. A 1966.Great hull shape for
Lake Erie (usually large waves). No Transom Plug, only one in the
forward Bilge.I've thought about a Transom plug, but the Zinc is
directly in the way. Thanks for the sealant recommendation. I'll see
if I can find that in my locale.- Hide quoted text -

- Show quoted text -

#3M 5200 is available at West Marine, Home Depot and many places in
between. It is REAL permanent but slow to fully cure so plan ahead.
Was me, I'l seal te edges of you newly cut hole with resin before
installing the drain assembly, just to be safe. About the transom,
could you relocate the zinc and then put in a drain there as well?
Have fun, nothing is more fun then messing around with boats!
Mike