I want to replace my anolog voltage meter with a LED meter that I can easily
read accurately at a glance.

I see them in the catalogs but don't notice any spec on the amount of
current they draw if I leave it on all or most of the time.

The way my power panel is set up (OEM), you have to push a momentary switch
to activate the anolog meter.. I never considered that this meter would draw
enough current to be of concern.

Presently, for accurate digital volt readings, I use my Fluke muli-meter but
if I leave that hooked up the 9 volt battery will run down.

Any thoughts??

Steve
s/v Good Intentions