Pulling steering wheel
 

Any tricks for pulling the plastic teleflex steering wheel. This sucker is
corroded on pretty good.
G

Pulling steering wheel
 

Mechanical helm. Can't use puller as wheel is plastic with metal insert.
Will destroy wheel.
Gordon
"Ron White" wrote in message
...
Assuming it is on a hydraulic helm, don't even tap on it a little. Use a
puller.

--
Ron White
My boatbuilding website is:
www.concentric.net/~knotreel

Pulling steering wheel
 

Any tricks for pulling the plastic teleflex steering wheel. This sucker is
corroded on pretty good.


Try loosening the nut enough to expose the shaft/ wheel interface and spray
some penetrating oil in there (likePB Blaster) After letting that soak loosen
the nut to the end of the shaft making sure the nut is still fully engaged in
the threads. This should allow for a gap between the nut & washer if there is
one and the wheel. While pulling hard on the wheel with your hands at the 9 & 3
o'clock positions, have someone (helper) rap on the shaft with a hammer and a
large punch. The nut will protect the threads.
I have done the same thing by myself by wedging my knees behind the wheel and
hitting the shaft

Be sure to grease it before reinstalling.

BR.

Pulling steering wheel
 

As a note of discouragement, I have more than the usual resources in
workshop tools, but still I ended up with a Sawzall in hand, hacking
the hub apart.

Brian W

On Sat, 16 Aug 2003 15:51:37 GMT, "GAZ" wrote:

Mechanical helm. Can't use puller as wheel is plastic with metal insert.
Will destroy wheel.
Gordon
"Ron White" wrote in message
...
Assuming it is on a hydraulic helm, don't even tap on it a little. Use a
puller.

--
Ron White
My boatbuilding website is:
www.concentric.net/~knotreel

Pulling steering wheel
 

On Fri, 15 Aug 2003 15:38:24 GMT, "GAZ" wrote:

Any tricks for pulling the plastic teleflex steering wheel. This sucker is
corroded on pretty good.
G


I remember reading a post in one of the boat groups about using the
difference in temperature between the two parts to do the work. This
guy dumped ice town a metal tube that was stuck in something, waited a
few minutes, and it popped right out, even after he had tried all
sorts of penetrating oils. The tube cooled faster than the part it was
stuck in.

I think plastic expands when warm, (heat gun), after cooling the whole
assembly with maybe some kind of cooling spray , or something really
cold? I don't know.

Hopenhelpin'
Donny



'74 Trojan Sea Raider 25'

http://www.picturetrail.com/sixbennetts

http://thebayguide.com/rec.boats/donny_bennett.html