QLW wrote:
I usually solder connector on my boat and have never found this to fail.
I've never see this done but the manufacturers so there must be some
negative reason but I've not found it.

Cost of assembly. It gets the boat out of the door, and it works long
enough to last until the end of the warranty.

--
the most committed always win

dazed and confuzed wrote:


Cost of assembly. It gets the boat out of the door, and it works long
enough to last until the end of the warranty.


I agree. The crimp is for a solid mechanical connection. The solder
gives a good electrical connection and resists corrosion.

Tom
of the Swee****er Sea

Tom, you are incorrect. A solder joint under vibration can easily create a
resistive connection and it can be undetectable until it overheats. Please
review my previous advice and use a crimping tool that creats a very high
pressure crimp.
Steve

"Tom Shilson" wrote in message
...
dazed and confuzed wrote:


Cost of assembly. It gets the boat out of the door, and it works long
enough to last until the end of the warranty.


I agree. The crimp is for a solid mechanical connection. The solder
gives a good electrical connection and resists corrosion.

Tom
of the Swee****er Sea