Home |
Search |
Today's Posts |
#21
![]() |
|||
|
|||
![]()
Alan Gomes wrote:
Peggy, What preventive maintenance do you typically recommend? I'm also using the Groco HF. Every time I'm through using it for several days (e.g., at the end of a trip), I flush it thoroughly with fresh water and run some head lube in it. What else do you recommend to avoid problems? That's a beginning... Once a week, or last thing before the boat is to sit unused, a quart of clean fresh water, followed by a cupful of white vinegar will help to prevent mineral buildup and odor permeation in head discharge hose. And it's VERY important to keep the pump lubricated. Many people just wait till the toilet starts to squeak and become hard to pump, then pour some mineral oil or vegetable oil down it. That’s ok in an emergency, till you can get home and do it right, but it’s not the way to maintain the toilet. Not only is this very hard on the toilet, but it’s a never-ending job because anything poured down the toilet washes out in just a few flushes. Why is it hard on the toilet? Because a toilet doesn’t squeak UNLESS it needs lubrication; that squeaking is the sound of seals rubbing against the inside of the housing, being worn away. Waiting till it squeaks to lubricate it is like waiting till an engine starts to smoke to add oil. There are two ways to approach it...the way you're doing it (the never-ending job of pouring something down the toilet every week or two), or you can do it just once a year. Ever wondered why a new toilet doesn’t need any lubrication for at least a year? It’s because every toilet leaves the factory slathered with thick Teflon grease that takes a full season or more to be flushed out. Replacing it just once a year as preventive maintenance is all it takes to keep a toilet pumping smoothly. And it’s only a 15 minute job—just open up the top of the pump and put a healthy squirt of it into it…pump the toilet a few times to get it all through the pump, and you’re “good to go” for the entire season. And, by keeping the pump lubricated this way, you extend the life of the seals and valves, reducing the need for rebuilds and repairs. Believe it or not, most people don't know how to flush a marine toilet...they stop pumping as soon as the bowl is empty, which leaves whatever was in the bowl sitting in the pump and hose..each flush pushes it a little further while adding another "batch" behind the last one. They're afraid to flush longer because they think that'll fill up their holding tanks too quickly. That's because they don't know how to use the dry mode. What they don't realize is, any marine toilet that's working even close to factory specs can move bowl contents up to 6' in the dry mode...that it's really only necessary to bring in flush water to rinse BEHIND the bowl contents...and rinsing out the discharge hose is important to prevent clogs. And finally, no matter how careful you are about keeping the toilet lubricated and keeping the head discharge hose rinsed out, sooner or later every pump has to be rebuilt. You can either wait till the bowl is full and won't go down (which is what most people do), or you can do it on a schedule as PREVENTIVE maintenance. A toilet that's kept well lubricated and flushed out should be rebuilt about once every 4-5 years...the joker valve replaced every 2 years. It's much more pleasant job if you do it when the toilet is clean and dry than it is to take a pump apart when the bowl is full, plus it all but eliminates the potential for clogs and backups. There's a lot more information that should go a long way toward preventing most "head aches" in my book (see link in my sig)...but those are the basics. Peggie ---------- Peggie Hall Specializing in marine sanitation since 1987 Author "Get Rid of Boat Odors - A Guide To Marine Sanitation Systems and Other Sources of Aggravation and Odor" http://www.seaworthy.com/html/get_ri...oat_odors.html |
#22
![]() |
|||
|
|||
![]()
I had two Groco EB's. I can't say enough bad about them. They're gone now,
replaced by a couple of Raritan PHII's. Pretty much foolproof. I do the annual greasing / maintenance as Peggie recommends. "Bill" wrote in message ... I had a vessel with a Groco head. Never had to do "preventative maintenance" because I was rebuilding it every few months. Hey, maybe that is Groco's idea of preventative maintenance. Got so I could do it blind folded. I even modified it slightly near the end of my sad experience with it. Bill "Peggie Hall" wrote in message ... sded wrote: I have two Groco HF heads that have seen nearly 17 years of use. I looked into other heads, but finally just did a complete pump replacement for the HFs. They have worked well, only needing a rebuild every year or two. Have you checked your discharge lines for clogging? He didn't mention what kinds of problems he's having with Groco...but it's amazing how many repairs wouldn't be necessary if there was any preventive maintenance done. But preventive maintenance is something that never occurs to most boat owners...they assume that because household toilets don't need any, marine toilets don't either. So the toilet works fine for about year or two--till it needs some...after that, it's never-ending battle to fix what breaks but didn't have to. And, of course, it's always because the toilet is a "piece of junk." Peggie ---------- Peggie Hall Specializing in marine sanitation since 1987 Author "Get Rid of Boat Odors - A Guide To Marine Sanitation Systems and Other Sources of Aggravation and Odor" http://www.seaworthy.com/html/get_ri...oat_odors.html |
#23
![]() |
|||
|
|||
![]()
I had two Groco EB's. I can't say enough bad about them. They're gone now,
replaced by a couple of Raritan PHII's. Pretty much foolproof. I do the annual greasing / maintenance as Peggie recommends. "Bill" wrote in message ... I had a vessel with a Groco head. Never had to do "preventative maintenance" because I was rebuilding it every few months. Hey, maybe that is Groco's idea of preventative maintenance. Got so I could do it blind folded. I even modified it slightly near the end of my sad experience with it. Bill "Peggie Hall" wrote in message ... sded wrote: I have two Groco HF heads that have seen nearly 17 years of use. I looked into other heads, but finally just did a complete pump replacement for the HFs. They have worked well, only needing a rebuild every year or two. Have you checked your discharge lines for clogging? He didn't mention what kinds of problems he's having with Groco...but it's amazing how many repairs wouldn't be necessary if there was any preventive maintenance done. But preventive maintenance is something that never occurs to most boat owners...they assume that because household toilets don't need any, marine toilets don't either. So the toilet works fine for about year or two--till it needs some...after that, it's never-ending battle to fix what breaks but didn't have to. And, of course, it's always because the toilet is a "piece of junk." Peggie ---------- Peggie Hall Specializing in marine sanitation since 1987 Author "Get Rid of Boat Odors - A Guide To Marine Sanitation Systems and Other Sources of Aggravation and Odor" http://www.seaworthy.com/html/get_ri...oat_odors.html |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
replace head on a mercruiser 350 engine | General | |||
OT--Not again! More Chinese money buying our politicians. | General | |||
Head Gasket on 50 HP 93 Evinrude | General | |||
head gasket failure, salt water in cylinders, question? | General | |||
Jabsco Head - help! | General |