Home |
Search |
Today's Posts |
#11
![]()
posted to rec.boats
|
|||
|
|||
![]()
On 10/25/2011 1:38 PM, John H wrote:
On Tue, 25 Oct 2011 07:39:48 -0400, wrote: On 10/24/2011 11:29 PM, Wayne.B wrote: On Mon, 24 Oct 2011 12:18:31 -0700, --@++.-- wrote: Recently my boat got pounded pretty good from behind by a bunch of wind produced waves. After that it didn't want to run because water got in the breather for the gas tank. I ran a line from a can of good gas and ran the engine and it cleared up and began running normally again. I got an electric fuel pump and attached it to the tank's fuel line and pumped out into portable cans. To me, at first it appeared to pump clean water, then it looked milky for a while, then it looked like clean gas. I pumped about 2 more gallons out of the 14+/- gallon tank after it began looking like good gas, and it still looked good so I stopped pumping. Is it safe to think the remaining gas is okay? Others here have given you good advice: 1. Best to empty and discard as much of the tank as possible (most of the water will be on the bottom and will slosh around when under way and get remixed with fuel). 2. Racor makes a really excellent bulkhead mounted fuel filter. It is more expensive than the Sierra but worth it in my opinion. The Racor has a drain tap on the bottom so you can see if water is accumulating in the filter bowl and get rid rid of it. Do they make glass bowl filters for inboard gas engines? Something like this should work. http://tinyurl.com/653qshq The link says the Coast Guard requires the metal bowl version on gas inboards. I thought that was the case. |
#12
![]()
posted to rec.boats,rec.boats.building,rec.boats.cruising
|
|||
|
|||
![]()
On Tue, 25 Oct 2011 09:31:19 -0400, Drifter wrote:
On 10/25/2011 7:42 AM, Tim wrote: On Oct 25, 6:39 am, wrote: On 10/24/2011 11:29 PM, Wayne.B wrote: On Mon, 24 Oct 2011 12:18:31 -0700, -...@++.-- wrote: Recently my boat got pounded pretty good from behind by a bunch of wind produced waves. After that it didn't want to run because water got in the breather for the gas tank. I ran a line from a can of good gas and ran the engine and it cleared up and began running normally again. I got an electric fuel pump and attached it to the tank's fuel line and pumped out into portable cans. To me, at first it appeared to pump clean water, then it looked milky for a while, then it looked like clean gas. I pumped about 2 more gallons out of the 14+/- gallon tank after it began looking like good gas, and it still looked good so I stopped pumping. Is it safe to think the remaining gas is okay? Others here have given you good advice: 1. Best to empty and discard as much of the tank as possible (most of the water will be on the bottom and will slosh around when under way and get remixed with fuel). 2. Racor makes a really excellent bulkhead mounted fuel filter. It is more expensive than the Sierra but worth it in my opinion. The Racor has a drain tap on the bottom so you can see if water is accumulating in the filter bowl and get rid rid of it. Do they make glass bowl filters for inboard gas engines? Sure! most of the older farm tractors had them, but they screwed into the base of the tank. I have seen some mountable in-line glass bowl units, though Should have been more specific and said boat inboard gas engine. === As I understand it, boats with enclosed bilges, which includes virtually all inboard engines, are not allowed to use glass or plastic filter bowls, only metal. That said, my Racor 1000s on the trawler have plastic bowls but that's a diesel boat. Some Racor 1000s are offered with a metal shield around the bowl, not sure about their smaller filters. |
#13
![]()
posted to rec.boats
|
|||
|
|||
![]()
On Tue, 25 Oct 2011 13:38:33 -0400, John H
wrote: On Tue, 25 Oct 2011 07:39:48 -0400, Drifter wrote: On 10/24/2011 11:29 PM, Wayne.B wrote: On Mon, 24 Oct 2011 12:18:31 -0700, --@++.-- wrote: Recently my boat got pounded pretty good from behind by a bunch of wind produced waves. After that it didn't want to run because water got in the breather for the gas tank. I ran a line from a can of good gas and ran the engine and it cleared up and began running normally again. I got an electric fuel pump and attached it to the tank's fuel line and pumped out into portable cans. To me, at first it appeared to pump clean water, then it looked milky for a while, then it looked like clean gas. I pumped about 2 more gallons out of the 14+/- gallon tank after it began looking like good gas, and it still looked good so I stopped pumping. Is it safe to think the remaining gas is okay? Others here have given you good advice: 1. Best to empty and discard as much of the tank as possible (most of the water will be on the bottom and will slosh around when under way and get remixed with fuel). 2. Racor makes a really excellent bulkhead mounted fuel filter. It is more expensive than the Sierra but worth it in my opinion. The Racor has a drain tap on the bottom so you can see if water is accumulating in the filter bowl and get rid rid of it. Do they make glass bowl filters for inboard gas engines? Something like this should work. http://tinyurl.com/653qshq ==== Yes, that's what I've ended up with on our dinghy after way too many "water in the gas" incidents. So far, so good. Since the dinghy has no bilge I can use the plastic bowl version and immediately see if water or dirt is collecting, and drain it off if so. |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
aux gas tank (use an outboard tank for an I/O) | General | |||
Gas Tank Question? | General | |||
WATER IN THE GAS TANK | General | |||
gas tank | General | |||
Water tank Accident. Was: water tank leak | Cruising |