Courtesy of Jamestown Distributors, one of the better sources for
marine supplies:

http://www.jamestowndistributors.com/userportal/videoDisplay.do?videoId=1415

The paint is Interlux Brightsides, one part polyurethane. There are
some good tips for thinning, brushing and preparation.

On 3/14/2013 6:45 AM, Wayne B wrote:
Courtesy of Jamestown Distributors, one of the better sources for
marine supplies:

http://www.jamestowndistributors.com/userportal/videoDisplay.do?videoId=1415

The paint is Interlux Brightsides, one part polyurethane. There are
some good tips for thinning, brushing and preparation.


I have used the Brightsides by Interlux before. Goes on great by hand...

On Thu, 14 Mar 2013 07:59:51 -0400, JustWaitAFrekinMinute
wrote:

On 3/14/2013 6:45 AM, Wayne B wrote:
Courtesy of Jamestown Distributors, one of the better sources for
marine supplies:

http://www.jamestowndistributors.com/userportal/videoDisplay.do?videoId=1415

The paint is Interlux Brightsides, one part polyurethane. There are
some good tips for thinning, brushing and preparation.


I have used the Brightsides by Interlux before. Goes on great by hand...

====

I've used it also. It looks very good if thinned properly and
applied with the right brushing technique. It takes practice to get
it right but I thought the video did a good job of pointing out some
of the basics.

On 3/14/2013 8:31 AM, Wayne B wrote:
On Thu, 14 Mar 2013 07:59:51 -0400, JustWaitAFrekinMinute
wrote:

On 3/14/2013 6:45 AM, Wayne B wrote:
Courtesy of Jamestown Distributors, one of the better sources for
marine supplies:

http://www.jamestowndistributors.com/userportal/videoDisplay.do?videoId=1415

The paint is Interlux Brightsides, one part polyurethane. There are
some good tips for thinning, brushing and preparation.


I have used the Brightsides by Interlux before. Goes on great by hand...

====

I've used it also. It looks very good if thinned properly and
applied with the right brushing technique. It takes practice to get
it right but I thought the video did a good job of pointing out some
of the basics.


The best tip I can give to anybody using it is don't try to use it in
direct sunlight. And yes, I thinned mine for roll and tip, if I remember
correctly about 10% or so.... I found that if you put down a very thin
coat of epoxy and then put the brightsides over it before the epoxy
cures out, it's bond is almost unstoppable.

On Thu, 14 Mar 2013 06:45:23 -0400, Wayne B
wrote:

Courtesy of Jamestown Distributors, one of the better sources for
marine supplies:

http://www.jamestowndistributors.com/userportal/videoDisplay.do?videoId=1415

The paint is Interlux Brightsides, one part polyurethane. There are
some good tips for thinning, brushing and preparation.

Thanks!