It has stamped on the inside, WT-20A
the boat was made in 1970, it must be newer than that.
Does anyone know anything about this transducer?
It has the typical arrow shape design !=
the wire plug where it would have attached to a depth sounder uses a small
screw on type connector with a simple center connector and ground shield
cable..
I was wondering if this is useful anymore for a depth sounder.

On Sat, 2 Oct 2004 17:09:30 -0400, "scott downey"
wrote:

It has stamped on the inside, WT-20A
the boat was made in 1970, it must be newer than that.
Does anyone know anything about this transducer?
It has the typical arrow shape design !=
the wire plug where it would have attached to a depth sounder uses a small
screw on type connector with a simple center connector and ground shield
cable..
I was wondering if this is useful anymore for a depth sounder.

How big is it?

Take care.

Tom

"The beatings will stop when morale improves."
E. Teach, 1717

Maybe 5.5 inchs long, 3.5 inchs wide.
The epoxy circle is about 2.5 inchs wide

"Short Wave Sportfishing" wrote in message
...

On Sat, 2 Oct 2004 17:09:30 -0400, "scott downey"
wrote:

It has stamped on the inside, WT-20A
the boat was made in 1970, it must be newer than that.
Does anyone know anything about this transducer?
It has the typical arrow shape design !=
the wire plug where it would have attached to a depth sounder uses a small
screw on type connector with a simple center connector and ground shield
cable..
I was wondering if this is useful anymore for a depth sounder.

How big is it?

Take care.

Tom

"The beatings will stop when morale improves."
E. Teach, 1717