Home |
Search |
Today's Posts |
#7
![]() |
|||
|
|||
![]()
Ken Ferschweiler wrote:
Steven Murch ) wrote: : Hi Gene, : I just got my compass, the same , 70P for my Romany 16. I went out and got : 4 # 4 machine screws 3/4" for the nut, with #4 washers and a nylon nut also : a #4. I also got the # 4 machine screw 1/2" to minimize the steel to the : compass if the 3/4" are too long. The screws that came with the compass are : #4 1/2". I had to search around town for the #4 hardware but was very lucky : to find them. I'll use a marine glue for the drill holes. I think the : drill holes will be 7/64. I would not go up to a #6 hardware. As crazy as : it may seem; its more steel to the compass. I was thinking of going without : the washers to keep steel away form the compass. It's not difficult to find machine screws in 316 stainless, which is pretty close to non-magnetic (but not perfect; anybody had a problem with stainless screws upsetting a compass?). Why not just use the screws that comes with the compass and be done with it? They work absolutely fine, which is why they're included. You guys have come up with a bunch of "solutions in search of a problem". There's no need to re-engineer this. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Compass needle versus card for cruising | Cruising | |||
Compass Information | General | |||
RDF for newbies and NN of KN | ASA | |||
Flux Compass input to radar?? | Electronics | |||
'Swinging' compass? | Cruising |